EposMoteIII Expasion Boards


This is a list of EposMoteIII's Expasion Boards, there are status information, key electronic components and link to board's full information (for finished boards).

EposMoteIII Expasion Boards Outputs Pins List

JTAG Board

  • Status: prelimary layout tested, waiting prototype batch fabrication.
  • Key components:
    • Connector Header 20 Positions .100 pitch (JTAG 20 ARM).
    • 2x Connector Header .100 pitch.
    • 6 pins Connector Header for UART0 (VCC, GND, TX, RX, CTS and RTS).
  • Projects: EposMoteIII
  • Board's full information: board finished, writing page about the connections.

IR Remote Controller / Air Conditioner Controller Board

  • Status: board finished, waiting for prototype PCB batch.
  • Key components:
    • SN74HC367 - Buffer and Line Drivers with 3-state outputs.
    • TSAL6200 - InfraRed LED.
    • TSOP58438 - InfraRed Receiver.
    • 8 pin expansion I/O for keypad.
  • Projects: EposMoteIII, SmartBuilding
  • Full information: board finished, writing board details page.

Serial Communication Board

  • Status: circuit requirements specification
  • Key components (not concluded):
    • SPI to CAN IC (MCP2515);
    • CAN Drivers IC;
    • LIN Physical Interface (SN65HVDA100-Q1);
    • UART to EIA232 IC (TRS3221);
    • UART to EIA485 IC (MAX14853).
  • Projects: EposMoteIII, Electric Kart
  • Full information: board not finished.

Data Logger Board

  • Status: circuit requirements specification
  • Key components (not concluded):
    • CPLD IC;
    • Flash Memory IC.
  • Projects: Torsional vibration wireless monitoring
  • Full information: board not finished.

Battery Monitor Board

  • Status: prototype fabricated, not fully tested.
  • Key components:
    • LTC2943 IC: Multicell Battery Gas Gauge;
    • (2x) Cold-Junction Compensated Thermocouple-to-Digital Converter
  • Projects: Hidrologic Station.
  • Full information: board not finished.

LiPo Battery Monitor Board

  • Status: circuit requirements specification
  • Key components (not concluded):
    • LiPo Battery Monitor IC;
  • Projects: Quadcopter.
  • Full information: board not finished.

Load Cell Signal Conditioning Board

  • Status: circuit requirements specification
  • Key components (not concluded):
    • HX711 IC: 24 bit analog-to-digital converter (ADC) for weigh scales.
  • Projects: Bee Keeping Monitor.
  • Full information: board not finished.