EposMoteIII Expasion Boards
This is a list of EposMoteIII's Expasion Boards, there are status information, key electronic components and link to board's full information (for finished boards).
EposMoteIII Expasion Boards Outputs Pins List
JTAG Board
- Status: prelimary layout tested, waiting prototype batch fabrication.
- Key components:
- Connector Header 20 Positions .100 pitch (JTAG 20 ARM).
- 2x Connector Header .100 pitch.
- 6 pins Connector Header for UART0 (VCC, GND, TX, RX, CTS and RTS).
- Projects: EposMoteIII
- Board's full information: board finished, writing page about the connections.
IR Remote Controller / Air Conditioner Controller Board
- Status: board finished, waiting for prototype PCB batch.
- Key components:
- SN74HC367 - Buffer and Line Drivers with 3-state outputs.
- TSAL6200 - InfraRed LED.
- TSOP58438 - InfraRed Receiver.
- 8 pin expansion I/O for keypad.
- Projects: EposMoteIII, SmartBuilding
- Full information: board finished, writing board details page.
Serial Communication Board
- Status: circuit requirements specification
- Key components (not concluded):
- SPI to CAN IC (MCP2515);
- CAN Drivers IC;
- LIN Physical Interface (SN65HVDA100-Q1);
- UART to EIA232 IC (TRS3221);
- UART to EIA485 IC (MAX14853).
- Projects: EposMoteIII, Electric Kart
- Full information: board not finished.
Data Logger Board
- Status: circuit requirements specification
- Key components (not concluded):
- CPLD IC;
- Flash Memory IC.
- Projects: Torsional vibration wireless monitoring
- Full information: board not finished.
Battery Monitor Board
- Status: prototype fabricated, not fully tested.
- Key components:
- LTC2943 IC: Multicell Battery Gas Gauge;
- (2x) Cold-Junction Compensated Thermocouple-to-Digital Converter
- Projects: Hidrologic Station.
- Full information: board not finished.
LiPo Battery Monitor Board
- Status: circuit requirements specification
- Key components (not concluded):
- LiPo Battery Monitor IC;
- Projects: Quadcopter.
- Full information: board not finished.
Load Cell Signal Conditioning Board
- Status: circuit requirements specification
- Key components (not concluded):
- HX711 IC: 24 bit analog-to-digital converter (ADC) for weigh scales.
- Projects: Bee Keeping Monitor.
- Full information: board not finished.